The following sections explain scenarios where active substances currently have the same status in the EU and Great Britain (GB).
There is separate guidance (scenarios 1 to 10) where active substances have a different status in the EU and GB.
The regulatory positions for these active substances are not currently changing, although there may be some differences to be aware of such as expiry dates.
The guidance below explains any impacts that the SPS Agreement will have on these scenarios, you should read existing guidance to understand what the status means and how to put products on the market. If you have any specific questions you can email [email protected].
If you have BPR product authorisations, Control of Pesticides Regulations (COPR) product approvals or on-going applications we will be in contact with you before 1 March 2028. If you have not been contacted, email [email protected].
This guidance is intended to help businesses prepare for implementation of the SPS Agreement. Details remain subject to legislative processes.
11. Approved
These active substances are approved for use in biocidal products of the listed product types in both the EU and GB.
Note there may be cases where an active substance is ‘approved’ in the EU, and ‘approved under renewal’ in GB. In these circumstances, the active substance/product type combinations will remain in this scenario until the renewal application status has been confirmed in the EU. If your active substance is in this situation, you should check its status regularly. Once the renewal application has been confirmed in both markets, the active substance/product type combination will move to scenario 12.
The affected active substance/product type combinations are in tab ‘Scenario 11’ of the SPS list of biocide active substances
The date of approval will have already passed for all the active substances in the relevant product type. This means currently in both the EU and GB, biocidal products containing these active substances in these product types should typically have product authorisation to be on the market.
Some product applications may be on-going in either jurisdiction for biocidal products containing these active substances. In this case the ability to place a product on the market will depend on the regulatory status and whether an application was submitted before the approval date of the active substance.
To place a new biocidal product on the market you will need to apply for and receive BPR product authorisation. Note you only need to apply for BPR product authorisation once the last active substance/product type combination in your product has been approved. Further details about how to apply via the EU system will be provided when available.
12. Approved under renewal
An active substance that is ‘under renewal’ in both the EU and GB remains approved for the relevant product types while the renewal applications are being assessed.
The affected active substance/product type combinations are in tab ‘Scenario 12’ of the SPS list of biocide active substances
The approval expiry dates may differ between the EU and GB where expiry dates have been postponed during the renewal process. Before 1 March 2028, the relevant EU and GB expiry dates continue to apply in their respective jurisdictions. After 1 March 2028, the EU expiry date will apply in GB.
Currently in both the EU and GB, biocidal products containing these active substances in these product types should typically have product authorisation to be on the market.
To place a new biocidal product on the market you will need to apply for and receive BPR product authorisation.
If you already hold BPR authorisation, the renewal application needs to be submitted 550 days before the authorisation expiry date.
An active substance that is ‘approved under renewal’ may be the subject of a renewal or non-renewal decision. If a renewal or non-renewal decision is taken in the EU, it will apply in GB from 1 March 2028. This will result in your active substance changing scenario. You should therefore monitor the EU status regularly. You can do this by checking the SPS list of biocide active substances or ECHA’s website. You should also ensure that you are subscribed to HSE’s ebulletins.
13. Under review
If your active substance/product type combination status is ‘under review’ in both the EU and GB, it will be ‘under review’ from 1 March 2028 unless further regulatory decisions are taken.
This means that biocidal products containing these active substances may be used in the relevant product types, subject to national rules.
The affected active substance/product type combinations are in tab ‘Scenario 13’ of the SPS list of biocide active substances
All decisions on approval taken by the EU Commission will be published in the Official Journal (EUR-Lex). HSE ebulletins will also be sent to inform stakeholders of the decision.
If a decision on approval is taken in the EU, it will apply in GB after 1 March 2028. This will result in your active substance changing scenario. You should therefore monitor the EU status regularly. You can do this by checking the SPS list of biocide active substances or ECHA’s website.
14. Under assessment
If your active substance/product type combination status is ‘under assessment’ in both the EU and GB, it will be ‘under assessment’ from 1 March 2028 unless further regulatory decisions are taken.
Biocidal products containing these active substances can only be made available on the market where a relevant derogation applies, such as the Article 93 transitional measure
The affected active substance/product type combinations are in tab ‘Scenario 14’ of the SPS list of biocide active substances
All decisions on approval taken by the EU Commission will be published in the Official Journal (EUR-Lex). HSE ebulletins will also be sent to inform stakeholders of the decision.
If a decision on approval is taken in the EU, it will apply in GB from 1 March 2028. This will result in your active substance changing scenario. You should therefore monitor the EU status regularly. You can do this by checking the SPS list of biocide active substances or ECHA’s website.
15. Not approved and non-inclusion
If your active substance/product type combination status is ‘not approved’ or ‘non-inclusion’ in both the EU and GB, it will be the same from 1 March 2028.
This means biocidal products containing these active substances cannot be made available on the market after any applicable phase-out period has ended.
The affected active substance/product type combinations are in tab ‘Scenario 15’ of the SPS list of biocide active substances
Where GB and EU deadlines for making available on the market and use of existing stocks differ, each jurisdiction's requirements continue to apply until 1 March 2028. After 1 March 2028, EU deadlines will apply to existing stock. Note where deadlines are passed in GB, no additional phase out will be applicable to the GB market in line with the EU deadlines.
16. Expired
If your active substance/product type combination status is ‘expired’ in both the EU and GB, it will be the same from 1 March 2028.
This means biocidal products containing these active substances cannot be made available on the market after any applicable period of grace or phase-out period has ended.
The affected active substance/product type combinations are in tab ‘Scenario 16’ of the SPS list of biocide active substances
Where GB and EU deadlines for making available on the market and use of existing stocks differ, each jurisdiction's requirements continue to apply until 1 March 2028. After 1 March 2028, EU deadlines will apply to existing stock. Note where deadlines are passed in GB, no additional phase out will be applicable to the GB market in line with the EU deadlines.
17. No longer supported
If your active substance/product type combination status is ‘no longer supported’ in both the EU and GB, it will be ‘no longer supported’ from 1 March 2028 unless further regulatory decisions are taken.
Biocidal products containing an active substance that is ‘no longer supported’ for the relevant product type can continue to be made available on the market until a non-approval decision is taken and published.
The affected active substance/product type combinations are in tab ‘Scenario 17’ of the SPS list of biocide active substances
Due to the SPS Agreement, we do not expect any GB BPR non-approval decisions to be made for these active substances. However, if the EU takes a non-approval decision before 1 March 2028 the active substance/product type combination will move to scenario 1.
You should regularly monitor its EU status in our SPS list and ensure that you are subscribed to HSE’s ebulletins so you are informed of any changes in the EU.
When a non-approval decision is taken by the EU after 1 March 2028 this will apply in GB.
18. Open invitation
If your active substance/product type combination status is ‘open invitation’ in both the EU and GB, it will be ‘open invitation’ from 1 March 2028 unless further regulatory actions are taken.
An active substance subject to an open invitation remains in the Review Programme while a new participant is sought to support the substance. This means that products containing these active substances that are at open invitation for the relevant product type can be made available on the market subject to national rules.
The affected active substance/product type combinations are in tab ‘Scenario 18’ of the SPS list of biocide active substances
Before 1 March 2028, GB and EU requirements continue to apply separately.
If any of these active substance/product type combinations are important to you, consider supporting the active substance in both the EU and GB. If a notification to take over the role of participant is not submitted the active substance/product type combination will be subject to a non-approval decision.
Be aware that the deadline for supporting an active under EU BPR may fall before 1 March 2028 when the SPS Agreement applies. Therefore you may need to take action to support the active under the EU BPR before 1 March 2028.
Note that after open invitation deadlines have passed the active substance/product type combinations will transfer to a new scenario depending on the status. You should check the status and scenario regularly to be aware of any upcoming actions.