Health and Safety Executive

This website uses non-intrusive cookies to improve your user experience. You can visit our cookie privacy page for more information.

Social media

Javascript is required to use HSE website social media functionality.

Firms fined over university death

A carpenter died when a large slab of concrete fell on him during construction of a new accommodation block at Bath University.

Philip Hames, of Weston-super-Mare, was working for Creagh Concrete Products on the University's Claverton Down Campus when he adjusted a metal prop without realising it was securing a concrete plank above him.

The concrete plank dropped onto Mr Hames, killing him instantly and narrowly missing a co-worker. The Health and Safety Executive (HSE) investigated the 1 November 2007 incident and has now brought a prosecution against Creagh.

Creagh Concrete Products Ltd of Blackpark Road, Toomebridge, County Antrim was found guilty of a breach of Section 3 (1) of the Health and Safety at Work etc Act 1974 and was fined £100,000 and costs of £140,000 at Bristol Crown Court.

The court was told the positions and type of props used in supporting the concrete plank were critical, however placement was largely left to the workers to decide. One end of the concrete plank rested on an asymmetric steel beam on a movement joint.

The court heard the designs produced by Creagh Concrete Products Ltd failed to communicate to workers the nature of the expansion joint. In adjusting the prop, Mr Hames inadvertently destabilised the asymmetric beam the plank was resting on.

The propping of a structure under construction is called the 'temporary works'.

Established British Standard and industry guidance was available to assist construction companies to plan work.

After the case, HSE Inspector Ian Smart, said:

"Unfortunately there has been a rise in the number of fatalities caused by the collapse of structures under construction or refurbishment over the past few years.

"Mr Hames was an experienced carpenter but Creagh failed to recognise the scope of the work he was undertaking and failed to ensure he was made aware of how critical the placements of the props were and the fact they should not be adjusted.

"Therefore, Mr Hames would not have understood the outcome of his actions. It was foreseeable he and other workers on site would seek to move props and robust steps should have been taken to prevent this.

"Since this incident, the published standard for temporary works has been revised. It provides additional clarity on respect of the safeguards associated with the temporary support of structures. It is crucial that this guidance is followed by the construction industry."

Notes to editors

  1. The Health and Safety Executive is Britain's national regulator for workplace health and safety. It aims to reduce work-related death, injury and ill health. It does so through research, information and advice; promoting training; new or revised regulations and codes of practice; and working with local authority partners by inspection, investigation and enforcement. www.hse.gov.uk
  2. Section 3 (1) of the Health and Safety at Work etc Act 1974 states: "It shall be the duty of every employer to conduct his undertaking in such a way as to ensure, so far as is reasonably practicable, that persons not in his employment who may be affected thereby are not thereby exposed to risks to their health or safety."
  3. Further information about safety on building sites can be found on the HSE website at http://www.hse.gov.uk/construction/index.htm
  4. The new British Standard, (BS 5975:2008 - Code of Practice for Temporary Works Procedures and the Permissible Stress Design of Falsework) published since this incident, clarifies how the temporary works should be managed on such a project and focuses on the competence of all parties. Propping layout drawings should be produced backed up by engineering calculations. It identifies the role of a temporary works co-ordinators whose role includes ensuring that safety critical information is shared between contractors. All propping should be regularly checked by a competent, person and in particular prior to any additional loading.
  5. HSE news releases are available at www.hse.gov.uk/press

Press enquiries

Regional reporters should call the appropriate Regional News Network press office.

Issued on behalf of the Health and Safety Executive by COI News and PR (South West)

Social media

Javascript is required to use HSE website social media functionality.

Updated 2012-06-14