Biopesticides are plant protection products which contain biological control agents (microbials, pheromones, plant extracts etc) for use as agricultural, horticultural and home garden pesticides. Further information is provided below.
Biocides are non-agricultural (public hygiene) pesticides (chemical or biological control agents) used to control unwanted pests and infections (excludes plant protection products) eg wood preservatives, insecticides, algaecides and repellents. Information about these products is found in the Biocides site.
'Biopesticide' covers a wide spectrum of potential products used as plant protection products, but for the purpose of our Biopesticide scheme these are divided into four categories:
Approvals are granted by HSE's Chemicals Regulation Division (CRD)on behalf of Ministers under a range of specific pesticide related legislation.
Applicants must provide supporting evidence that their pesticide products are safe and effective before an approval can be issued. This includes biopesticides. Following a pilot, the Biopesticides scheme was launched which offers reduced fees for biopesticides evaluations (Fees information page).
See further details of the biopesticide scheme.
There are a set of data requirements for all pesticides, and there are specific data requirements pertinent to the different categories of biopesticides, (please see the specific category types). The following list gives those new to the registration process a feel for the areas considered by our risk assessment:
Information on gaining active substance approval can be found at Introduction to the EU decision making process for active substances.
Full details on how to submit an application are given in The Applicant Guide however this is a summary:
We understand that if you are new to the regulatory process the system may seem complicated. CRD can offer assistance and advice. We urge potential applicants to contact us at the early stages of product development to ensure any work carried out can be consider in the light of regulatory requirements, thus ensuring the most cost effective way to gain approval. When contacting us, it would be very helpful if you would provide the following information:
Please contact the Biopesticides champion: Tel 01904 455952 or email: firstname.lastname@example.org.
We can arrange pre-submission meetings where we can give specific guidance to applicants, discuss data requirements in detail, dossier preparation and advise on the best way forward. There may be a charge for these meetings.
All enquiries submitted to CRD are treated as commercial in confidence.
The intended use of a pheromone will determine whether an assessment of a pheromone as active substance of a plant protection product is required, as well as the need of authorisation of a product as a plant protection product. A pheromone is considered as active substance of a plant protection product, if the pheromone aims to protect the plant.
This is the case when the pheromone is used for sexual confusion or in the case of mass trapping. However, pheromones are not considered as active substances of plant protection products, when they are used to only monitor the population cycle of the insects.
Such traps used for monitoring purposes may contain the same substances assessed under 1107/2009, but in this case neither the product has to be considered as plant protection product, nor has the pheromone to be considered as active substance in the sense of Regulation 1107/2009.
Also the case of a pheromone added to attract insects which in the end are killed by an insecticide is another situation. Then the pheromone can be considered as adjuvant in a sort of formulation, where the active substance is the insecticide and therefore in this case the pheromone itself is considered out of the scope of the Regulation.
Semiochemicals are chemicals emitted by plants, animals and other organisms — and synthetic analogues of such substances — that evoke a behavioural or physiological response in individuals of the same or other species. They include pheromones and allelochemicals.
Guidance on data requirements for pheromones and other semiochemicals can be found in Guidance for Registration Requirements for Pheromones and Other Semiochemicals Used for Arthropod Pest Control' (OECD Series on Pesticides, number 12).
In addition draft guidance number 220 Data Requirements and Trials Design for Mating Disruption Pheromone Products is available.
New Guidance document currently being produced.
The data you need to submit for the approval of a pesticide containing a microbial that is new to the UK/EU must be sufficient to allow a full risk assessment to be performed. The data requirements you need to address are not as extensive as those set for chemical active substances but take into account specific factors for microbials eg pathogenicity/infectivity in humans and animals, sensitisation of users, the production of toxins and the potential for multiplication in the environment.
Data requirements should be fulfilled at strain level unless it can be proved that it is not necessary for the particular strain in question. For more details see Taxonomic level of micro-organisms to be included in Annex I to Directive 91/414/EEC (doc. Sanco/10754/2005) found under Procedural Guidance/Procedures.
The following Guidance documents can be found on the European Commission Website:
There is a large spectrum of plant extracts, ie unprocessed extracts representing a 'cluster of substances' or highly refined containing one active substance. In addition the risk associated with the use of plant extracts may vary between low and very high risk, for this reason they are assessed on a case by case basis.
There is a European Commission working document which specifies data requirements for active substances of plant protection products made from plants or plant extracts, SANCO/11470/2012 found under Procedural Guidance/ Dossier and draft assessment report.
As the description suggests these are potential products which do not easily sit within a specific category and as such the data requirements will have to be assessed on a case by case basis. If you have such a product please contact us in order for us to consider if it is eligible for the biopesticides scheme and consider data requirements.
You must apply for a Trials Permit if you wish to carry out research and development work (including developing IPM systems) involving the release into the environment of an approved or unapproved active substance and/or pesticide that is not approved for the proposed use. More information can be found the Trials Permit section.